Service No
| Citation: |
ZHAO Lijuan, ZHANG Zhijun, GAO Weifeng, GUO Jiawei, HE Tianyi, LIU Yixin. Influence of Nozzle Position and Structure on the Ejection Performance of Liquid-Gas Jet Pump[J]. CHINESE JOURNAL OF VACUUM SCIENCE AND TECHNOLOGY, 2024, 44(12): 1019-1025. DOI: 10.13922/j.cnki.cjvst.202409002
|
In response to the complex internal flow process and low efficiency of liquid gas jet pumps, this paper uses Fluent software to analyze the variation law of the internal flow field of liquid gas jet pumps. The influence of different throat diameter ratios, nozzle positions, and nozzle structures on the jet performance of liquid gas jet pumps was simulated and studied. The results show that the ratio of the throat diameter of the jet pump to the nozzle outlet diameter directly affects the jet performance of the jet pump, and there is an optimal throat diameter ratio. When the throat diameter ratio is 2, the injection coefficient of the jet pump is maximized. When the distance between the nozzle of the jet pump and the inlet of the mixing chamber is different, the injection performance of the jet pump is also different. When the nozzle distance is 70 mm, the injection coefficient of the jet pump is the highest. When different nozzle structures are used, the cosine nozzle has the best injection performance, while the cylindrical nozzle has the worst injection performance.
| [1] |
孙琬婷, 李民. 射流泵喉管结构优化及模型放缩机理研究[J]. 流体机械,2023,51(11):63−70 (in Chinese) doi: 10.3969/j.issn.1005-0329.2023.11.010
Sun W T, Li M. Numerical simulation of throat structure optimization of jet pump and exploration of model contraction mechanism[J]. Fluid Machinery,2023,51(11):63−70 doi: 10.3969/j.issn.1005-0329.2023.11.010
|
| [2] |
王志艳, 胡林静, 席东民, 等. 混合室结构对蒸汽喷射器性能的影响[J]. 真空科学与技术学报,2020,40(2):180−186 (in Chinese)
Wang Z Y, Hu L J, Xi D M, et al. Influence of mixing chamber structre on entrainment ratio of steam ejector: a simulation study[J]. Chinese journal of vacuum science and technology,2020,40(2):180−186
|
| [3] |
李同卓, 杨志朋, 温小萍. 射流泵内置翼片不同倾角流体混合效果及流场数值模拟[J]. 河南理工大学学报(自然科学版),2022,41(6):123−129 (in Chinese) doi: 10.3969/j.issn.1673-9787.2022.6.jzgxyxb202206014
Li T Z, Yang Z P, Wen X P. Numerical simulation of mixing effect and flow field of internal vane of jet pump with different inclination angles[J]. Journal of Henan Polytechnic University(Natural Science),2022,41(6):123−129 doi: 10.3969/j.issn.1673-9787.2022.6.jzgxyxb202206014
|
| [4] |
张国玉, 王晓冬, 刘静雯. 喷嘴出口状态对水蒸汽喷射器流动行为及其性能的影响[J]. 真空科学与技术学报,2023,43(9):762−770 (in Chinese)
Zhang G Y, Wang X D, Liu J W. Numerical investigation of the nozzle exit state and its effect on the performance of the steam ejector[J]. Chinese journal of vacuum science and technology,2023,43(9):762−770
|
| [5] |
许志敏, 林丽生. 蒸汽喷射泵部分结构参数对其性能影响的研究[J]. 机械研究与应用,2017,30(3):67−70 (in Chinese)
Xu Z M, Lin L S. Study on effects of structural parameters of steam jet pump on its performance[J]. Mechanical Research & Application,2017,30(3):67−70
|
| [6] |
Yuan Y, Tan L, Xu Y, et al. Three-dimensional CFD modeling and simulation on the performance of steam ejector heat pump for dryer section of the paper machine[J]. Vacuum,2015,122:168−178 doi: 10.1016/j.vacuum.2015.09.016
|
| [7] |
Banasiak K, Hafner A, Andresen T. Experimental and numerical investigation of the influence of the two-phase ejector geometry on the performance of the R744 heat pump[J]. International Journal of Refrigeration,2012,35(6):1617−1625 doi: 10.1016/j.ijrefrig.2012.04.012
|
| [8] |
Shah A, Chughtai I R, Inayat M H. Experimental and numerical investigation of the effect of mixing section length on direct-contact condensation in steam jet pump[J]. International Journal of Heat and Mass Transfer,2014,72:430−439 doi: 10.1016/j.ijheatmasstransfer.2014.01.032
|
| [9] |
Zhang Q, Huo J, Liu R, et al. Numerical simulation and performance study of steam ejector using CFD[J]. Advanced Science Letters,2011,562-564(6-7):1150−1154
|
| [10] |
许鹏宇, 王凯, 崔峰源, 等. 不同几何尺寸蒸汽喷射器的三维模拟研究[J]. 山东化工,2021,50(13):173−175 (in Chinese)
Xu P X, Wang K, Cui F Y, et al. Three-dimensional simulation study of steam ejectors with different geometric dimensions[J]. Shandong chemical industry,2021,50(13):173−175
|
| [11] |
胡词, 张庆, 宁野, 等. 喷射泵性能优化设计及其力学性能研究进展[J]. 山东化工,2021,50(19):68−70 (in Chinese) doi: 10.3969/j.issn.1008-021X.2021.19.025
Hu C, Zhang Q, Ning Y, et al. Research progress on optimal design and mechanical proper tiesof pump[J]. Shandong chemical industry,2021,50(19):68−70 doi: 10.3969/j.issn.1008-021X.2021.19.025
|
| [12] |
赵丽娟. 液固射流混合过程的模拟与实验研究[D]. 沈阳: 东北大学, 2020 (in Chinese)
Zhao L J. Simulation and experimental study on mixing process of liquid-solid Jet[D]. Shenyang: Northeastern University, 2020
|
Supported by: Beijing Renhe Information Technology Co., Ltd. 
DownLoad: